Changing Triggerless to Triggered Configuration
To change from Triggerless to Triggered configuration:
Remove the Comfort Pad (see
1.
Remove the Triggerless Strap Holder (see
2.
Install the Trigger Swivel Assembly (see
3.
Install the Comfort Pad (see
4.
Perform a cold boot (see
5.
Press and release the Scan Trigger to enable the manual triggering mode (this operation disables the default
6.
Triggerless mode).
Resetting the Imager
If the Imager stops responding to input, reset it. There are three reset functions, warm boot, cold boot and clean
boot. Perform a warm boot first. If the Imager still does not respond, perform a cold boot. Perform clean boot to
restore the Imager to its factory default configuration.
Warm Boot
To perform warm boot, press and hold the Restore Key for more than six seconds.
Cold Boot
Cold boot restores the Imager's operation by resetting its software. To perform cold boot, remove and re-insert the
battery into the Imager. When using a corded Imager model with WT4090, remove and reconnect the interface
cable that connects between the Imager and the WT4090.
Clean Boot
Clean Boot restores the Imager to its factory default configuration.
To perform clean boot:
Remove battery or disconnect the Corded Adapter.
1.
Press and hold the Restore Key.
2.
Insert the battery or Corded Adapter into the Imager.
3.
Continue to press and hold the Restore Key for about five seconds until a chirp is heard and the Scan LEDs
4.
flash green. The Imager is now in its factory default configuration.
NOTE The factory default configuration is set in the factory or the service center. These parameters are unique
for each Imager and cannot be changed. The Factory default configuration includes: Imager serial
number, Bluetooth Device (BD) address, model number, production date and proximity calibration.
Comfort Pad Replacement on page
Triggerless Strap Holder Replacement on page
Trigger Swivel Assembly Replacement on page
Comfort Pad Replacement on page
Cold Boot on page
1-17).
Getting Started 1 - 17
3-3).
3-6).
3-4).
3-3).