Unit Name Field; Dhcp Radio Buttons; Gateway Ip Address Field; Subnet Mask Field - Extron electronics DMP 128 User Manual

On password-protected connections, there are two levels of protection: administrator
and user. Administrators have full access to the passwords and firmware upgrade pages.
Users have view only access.
• Ethernet connection to the device, either entering SIS commands
(see SIS Programming and Control
DSP Configurator Program, (see
page 16), is password protected.
• Connection via any RS-232 port is not password protected.
iP settings Panel
The IP settings fields provide a location for viewing and editing settings unique to
the Ethernet interface. After editing any of the settings on this page, click Submit at the
bottom of the section.

unit name Field

The Unit Name field contains the name of the device. This name field can be changed to
any valid name, up to 24 alphanumeric characters.
notE: The following characters are invalid in the matrix name:
+ ~ , @ = ' [ ] { } < > ' " ; : > \ and ?.

DhcP radio Buttons

The DHCP On button directs the device to ignore any entered IP addresses and to obtain
its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the network
is DHCP capable). The DHCP Off button turns DHCP off. Contact the local system
administrator for additional information on your network.
iP address Field
The IP Address field contains the IP address encoded in the flash memory of the
connected device.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots
(periods). Each field can be numbered from
3 digits total per field, are optional. Values of 256 and above are invalid.
The factory-installed default address is 192.168.254.254, but if this conflicts with other
equipment at the installation site, change the IP address to any valid value.
notE: IP address changes can cause conflicts with other equipment. Only local
system administrators should change IP addresses.

gateway iP address Field

The Gateway IP Address field identifies the address of the gateway to the mail server
to be used if the device and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.

subnet Mask Field

The Subnet Mask field determines whether the device is on the same subnet as the mail
server when you are subnetting.
on page 129) or using the Extron
DSP Configurator Program Basics
through . Leading zeroes, up to
000 255
DMP 128 • HTML Operation
on
158