Dsp Configurator Windows Menus; Keyboard Navigation - Extron electronics DMP 128 User Manual

DsP configurator windows Menus

Keyboard navigation

DSP Configurator is fully navigable using the computer keyboard. Some keyboard
navigation behavior matches Windows standards, while other behaviors are specific to
DSP Configurator.
<Tab> jumps to the various sections outlined in red in figure 61, below. When the program
starts, the cursor defaults to the Emulate button ( a ). Press <Tab> to jumps focus to the
next area, then the next, in order.
Within the sections, the <navigation arrows> move one processor block or mix-point right,
left, up, or down within the section.
d
f
k
p
q
r
Figure 61.
standard windows navigation
The keyboard keys navigate and function as follows:
•
b Live mode
c Presets (Down arrow can select presets)
d Outputs minimize button
e Output signal path (defaults to trim)
f Input minimize button
g Input signal processing (defaults to gain)
h Main mix-points
i Virtual Send bus mix-points
j Expansion Send bus mix-points
g
Outputs
h
Inputs
Virtual Returns
Expansion Returns
Exp. Inputs 1 - 8
Exp. Inputs 9 - 16
l
DSP Configurator Program
Tab key —
Sequentially jump among major segments of the DSP Configurator program. From the
Emulate mode button ( a ), sequential jumps are in the following order:
c e b a
i j
m n o
k Virtual Returns minimize button
l Virtual Return signal path (defaults to FBS)
m Virtual Return bus mix-points
n Virtual Return bus to Virtual sends
o Virtual Return bus to EXP sends
p EXP Returns bus minimize button
q EXP Inputs bus 1-8 maximize button
r EXP Inputs bus 9-16 maximize button
DMP 128 • Software Control 97