Extron electronics DMP 128 User Manual page 169

7. Click Next (see figure 91, g on the previous page). The program extracts and places
the firmware files in a folder identified in the InstallShield Wizard dialog box.
notE: The download folder can change depending on the operating system.
Note the folder where the firmware file is saved.
8. Click Finish (figure 91,
9. Connect the PC to the DMP 128 via the Ethernet port.
10. Access the device using the HTML pages (see
page 155).
11. Click the Configuration tab (see figure 92) to open the configuration page.
12. Click the Firmware Upgrade link on the
The current firmware version is displayed above the upload field for reference.
11
System Settings
12
Passwords
Firware Upgrade
Figure 92.
13.
Click Browse. An
14. Navigate to the firmware file folder noted in step 7, and select the firmware file.
notE: Valid firmware files must have the file extension '.S19'. Any other file
extension is not a firmware upgrade. The original factory-installed firmware is
permanently available on the device. If the attempted firmware upload fails for
any reason, the device automatically reverts to the factory-installed firmware.
15. Click Open.
16. Click Upload. The firmware upload to the device can take a few minutes.
h ) to exit the program.
Current Firmware Version: 1.02
Firmware Upgrade Page
dialog box opens.
Open File
Download the Startup Page
page.
System Configuration
DMP 128 • HTML Operation
on
163