Rename An Input Or Output - Extron electronics DMP 128 User Manual

rename an input or output

To simplify setup and operation of large matrix systems, rename the input (receiver) and
output (transmitter) lines to a label indicating the input a source device is connected to or
the output a receiver is connected to.
3
Figure 75.
to rename an input:
1. From the menu, select Device > Device View or use <Ctrl+D>.
2. From the drop-down list in the upper center of the screen, select the device.
3. From the
4. Click inside the input text box to rename. A cursor appears.
5. Type the new name (up to 30 characters) using any combination of letters, numbers,
and special characters.
6. Press <Enter>, or click in another input text box.
7. Repeat steps 4 to 6 for each input line.
8. When all Inputs have been renamed, close the dialog box.
to rename an output:
1. Follow steps 1 and 2 above.
2. From
Device View
3. The transmit tab has an extra column for naming the outputs. Click inside the
Channel Label text box to rename an output. A cursor appears.
4. Type a new name (up to 30 characters) using any combination of letters, numbers,
and special characters.
5. Press <Enter> or click in another output Channel Label field.
6. Repeat steps 3 to 5 for each input to be renamed.
7. When all outputs have been renamed, close the dialog box.
2
4
Dante Controller - Rename Inputs and Outputs
screen, select the Receive tab.
Device View
, select the Transmit tab.
DMP 128 • Software Control 121