Symbol Definitions; Special Characters - Extron electronics DMP 128 User Manual

symbol Definitions

]
Carriage return/line feed
=
}
Carriage return (no line feed)
=
•
Space character
=
|
=
Pipe (can be used interchangeably with the
*
Asterisk character (which is a command character, not a variable)
=
E Escape key
=
W
=
can be used interchangeably with the
X6)
= Gain and trim control
=
X6! Level value;
( d )
post-mixer trim
( a )
mic/line gain
b
( )
pre-mixer gain , virtual return gain
c
( )
, and output volume
X6$
= Mute status
X6%
= Group master group number
X6^
= Group fader setting
X6&
=
Group fader increment
X6*
=
Group fader soft limit
X6(
= Group type
X7)
=
Personal Identification Number (PIN)
X7!
=
Protected configuration status

special characters

The HTML language reserves certain characters for specific functions. The device will
not accept these characters as part of preset names, the device's name, passwords, or
locally created file names.
The DMP 128 rejects the following characters:
{space (spaces are OK for names)} + ~ , @ = ' [ ] { } < > ' " ; : > \ ?
}
character)
E
character
See table 1 on page 147.
See table 2 beginning on page 149 .
12.0
- dB to +
18.0
– dB to +
100.0
– dB to +
e
( )
notE: Output volume only, –
0
= unmute
1
= mute
01 – 32
dB value, in 0.1 dB increments using a 10x multiplier and negative numbers, but
not decimal places. The valid range depends on the type of gain block that is
assigned to the group number (
a
180
= – to
b
1000
= –
c
1000
= –
d
120
= – to
e
1000
= –
notE: Leading zeros are ignored.
0.1
dB value, in
0.1
dB value, in
for the gain block grouped in
6
= gain
12
= mute
Four numeric digits, default =
0
= no protected configuration saved
1
= protected configuration saved
to
12.0 1928 2168
dB, ( ) in
80 1868 2848 0.1
dB, ( to ) in
12.0 1048 2168
dB, ( to ) in
100.0
dB to +
X6%
) specified in the command:
800
(– 18.0 dB to +80.0 dB)
120
to (– 100.0 dB to +12.0 dB)
120
to (-100.0 dB to + 12.0 dB)
120
(– 12.0 dB to +12.0 dB)
000
to (– 100.0 dB to +0.0 dB)
dB increments, to raise or lower a group fader
dB increments. The valid range
X6%
.
0000
DMP 128 • SIS Programming and Control
0.1
dB increments.
dB increments.
0.1
dB increments.
to
0.0 1048 2048
dB ( ).
X6^
must be within the range
142