Creating A Physical Dante Network; Basic Configuration - Extron electronics DMP 128 User Manual

creating a Physical Dante network

Basic configuration

A physical network is required to share Dante audio channels between DMP 128 AT
devices. Each DMP 128 AT contains a 4-port Gigabit switch with four RJ-45 connectors
located on the back panel to accept standard network cables. The 4-port switch can
operate as a standard switch described in this section or in redundant mode (see
Redundant Configuration
streams during a single network failure, preventing audio stream interruption.
notE: The Dante Controller network configuration defaults to switched mode
A DMP 128-based Dante network can be configured in a daisy-chain or Star network
topology using the four port switch and the Dante Controller in Switched mode.
Star network topology has one DMP 128P AT as the central unit, which is then directly
connected to up to three other units. Alternatively, a larger network switch can be used in
place of the central DMP 128 AT, allowing more than three units to be connected in the
star configuration (see figure 69).
DMP 128 AT #1
Figure 69.
A daisy chain configuration can also be used. Each unit is connected to both the previous
unit and the next unit in the chain (see figure 70).
DMP 128 AT MASTER
Figure 70.
Hybrid versions combining the star and daisy chain topologies can also be built, but a ring
topology, or any topology that creates a duplicate connection causes a connection failure
in the Dante Controller software. Redundant connections are possible using the primary
and secondary port interface structure (see
notE: Connections between DMP 128 AT ports in either a star or daisy chain
on page 117) that switches between duplicate audio
(basic) making star and daisy-chain configurations possible. When configured
for redundant operation, different connection rules apply (see
Configuration on page 117).
1 2 3 4
RS-232
RESET
Tx Rx G EXP LAN
Star Network Topology
DMP 128 AT #1
1 2 3 4 1
RS-232 RS-232
RESET
Tx Rx G EXP LAN Tx Rx G
Daisy Chain Topology
network do not need to be sequential, nor do they need to be made between the
same port numbers.
DMP 128 AT #2
1 2 3 4
RS-232 RESET
Tx Rx G EXP LAN
DMP 128 AT #4
1 2 3 4
RS-232 RESET
Tx Rx G EXP LAN
Central Unit
Star Network Topology
DMP 128 AT #2
2 3 4 1 2
RS-232
RESET
EXP LAN Tx Rx G EXP
Daisy Chain Network Topology
Redundant Configuration
DMP 128 • Software Control
Redundant
DMP 128 AT #3
1 2 3 4
RS-232
RESET
Tx Rx G EXP LAN
DMP 128 AT #3
3 4 1 2 3
RS-232
RESET
LAN Tx Rx G EXP LAN
on page 117).
4
RESET
116