Telephone Dialer - Extron electronics DMP 128 User Manual

telephone Dialer

A telephone dialer is provided to aid setup and
troubleshooting.
to use the telephone dialer:
From the main DSP Configurator screen toolbar,
select Tools>Phone Dialer (see figure 80).
The phone dialer dialog box opens (see figure 81,
below).
The phone dialer uses the connected telephone
lines and provides the same features as a normal
dialing interface to assist the installer with setup and
testing.
to dial a number:
•
•
The dialer dialog has the following features:
•
•
•
•
•
•
•
•
Enter a phone number using the keyboard or the
number keypad, then place the phone off hook by
clicking the off/on hook icon, or
Place the phone off hook by clicking the off/on
hook icon, then enter the phone number using the
number keypad.
Caller ID readout field — displays the caller ID
of an incoming call.
Phone Number readout field — displays the
last outgoing number dialed.
Hook Off/On Button — toggles the phone
between "Off" the hook (green-connected) or "On"
(red-disconnected or hang up).
Number keypad — number can be dialed before
or after engaging "Hook Off".
Flash Button — a single press enables call
waiting or conference dialing.
Clear — clears current phone number.
Line Status Readouts
Line voltage — Measures the line voltage of
•
a connected phone line.
Loop Current — Measures the closed loop
•
current of a connected phone line.
Enable Pulse Dialing — when checked,
switches the dialing method from tone to pulse.
Figure 80. Select Phone Dialer
Figure 81. Phone Dialer
DMP 128 • Software Control 127