Connection Of Electrical Supply; Connection Of Pneumatic Air Supply - Pro Spot PHS-101 Instruction Manual

Battery operated dc spot welding system

Hide thumbs Also See for PHS-101:

Table of Contents

Hybrid Spot

3.5 Connection of electrical supply

Air supply port

Battery charging system:

The Hybrid Spot welder is equipped with an on-board charging system that

will charge all 4 batteries at once.

To activate charging, simply plug in the power cord to the outlet on the back

of the welder Fig 3.2 and the supply 120VAC or 240VAC for Europe, Australia,

and China. The power supply switches automatically between

120VAC and 240VAC.

It is possible to weld while the charging is activated; the charger will automatically

switch off when welding. The charger will turn back on 2 minutes after the last weld is

made. To check each battery's voltage, turn the WELD switch to Bat 1 Test,

Bat 2 Test, etc.

To check the battery under load press "PUSH TO TEST BATTERY" button

for 3 seconds to see loaded voltage. Repeat for each battery.

The Hybrid Spot welder must be connected to a pneumatic air network.

(100 PSI to 130 PSI)

1. Connect the welder to the air supply via the threaded input port at

the rear of the welder using a standard connector.

2. If not already set, adjust the air pressure setting on the welder front panel to

90 PSI (4-5 bar) (refer to section 4.5 "Setting the pneumatic air pressure").

IMPORTANT! The air must be clean and free from oil and

moisture. Use a filter.

IMPORTANT!

Figure 3.2

humidité. Utilisez un filtre.

3 Installation

L'air doit être propre sans huile et

Page 9

Table of Contents

Hybrid spot