Aile-Flap ( Glid 2A+2F Only); Spoiler Mix - RadioLink AT10 Instruction Manual

AILE-FLAP ( GLID 2A+2F only):

Adjustability:
• RATE
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW : See p. 26.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate AILE-FLAP
GOAL of EXAMPLE:
Turn on AILE-FLAP mixing. Set rate
to100% for maximum possible flap
travel with ailerons. Assign to SWITCH
C center.
Where next?
SPOILER MIX ( GLID
MIX works linking with BUTTERFLY function.
This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag.
models in speed runs, you may wish to use a larger value approaching 100%.
STEPS:
Open AILE-FLAP submenu.
Activate the function.
Set the rate. (Ex: 100% each way)
Assign the SWITCH and position.
Close.
ELEV-FLAP mixing. See p. 48.
BUTTERFLY . See p. 48.
Use a mix to OFFSET
View additional model setups on the internet: www.radiolink.com.cn/doce.
64
INPUTS:
for 1 second.
(If BASIC ,
C to AILE-FLAP .
C to MIX to ON .
C to FLP1 .
AILERON STICK.
AILERON STICK.
Repeat above to set FLP2 .
C to SW . to C .
to POSI . to CENTER .
C
again.)
to +100% .
to +100% .
SPOILER