Servo Display - RadioLink AT10 Instruction Manual

GOAL of EXAMPLE:
SUB-TRIM untilits
center exactly matches the aileron
servo's center, as they are to work
Where next?
SERVO display and cycle submenu: displays radio's output to channels 1-10.
GOAL of EXAMPLE:
View the result of reassigning channel
6 from VR(A) knob to three-position
SWITCH C.
Cycle the channel 6 servo.
Where next?
FailSafe (loss of clean signal and low receiver battery) submenu F/S ): sets responses in case of loss of signal or low Rx
Battery.
FailSafe ( F/S
STEPS:
Open BASIC menu, then open SUB-TRIM .
Choose the channel to adjust, andadjust
Repeat for other channels.
Close.
Adjust trim steps: see p. 35.
Adjust END POINTs : see p. 27.
The servo submenu includes two features:
• real-time bar-graph display to demonstrate exactly what commands the
transmitter is sending to the servos. (This can be particularly handy in setting
up models with complicated mixing functions, because the results of each
stick, lever, knob, switch input and delay circuit may be immediately seen.)
(channels 1-8)
STEPS:
C o m p l e t e d e s i r e d p r o g r a m m i n g
function. (Ex: in AUX-CH , move ch. 6 to
SWITCH C)
Open the SERVO function.
Move each control to see exactly how
operating. (Ex: SWITCH C in all
positions)
Prepare all servos to be cycled and cycle. Plug in servos. POWER ON.
End cycling and close.
Set up desired programmable mixes: see p. 47.
Set up dual aileron servos: see p. 39.
Set up dual elevator servos: see p. 44.
Adjustability:
•Each channel may be set independently.
• The NOR (normal) setting holds the servo in its last commanded position.
• The F/S (FailSafe) function moves each servo to a predetermined position.
• NOTE: the setting of the throttle's F/S also applies to the Battery F/S (see
below).
37
INPUTS:
for 1 second.
C to SUB-TRIM .
C to FLAP
as needed.
as needed.
D/R , EXP ): see p. 30.
INPUTS:
See AUX-CH for details. (p. 34.)
for 1 second.
to SERVO .
C
C to center position.
Note change in position of ch. 6 servo.
D/R , EXP ): see p. 30.
(
(If ADVANCE , again.)
to each channel,
C
(If ADVANCE , again.)