Elev-Flap Mixing (See Glid Menu 3.3.7); Aile-Flap(Glid 2A+2F Only); Spoiler Mix (Glid) - RadioLink AT10II Instruction Manual

Goals
Open AIL/RUD-MIX
submenu.
Select the mixing mode.
Ex:RUDD-AILE,
25%,no switch,
Activate the function
corrects roll
coupling.
Set the rate (Ex:100%
each way)
Close

ELEV-FLAP mixing (see GLID menu 3.3.7)

4.3.10

4.3.11 AILE-FLAP(GLID 2A+2F only):

This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag. For normal flying, a
value of about 50% is often used. For slope racing or F3B models in speed runs, you may wish to
use a larger value approaching 100%.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite aileron action from flaps.
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate
the mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE-FLAP settings for each flight condition can be set.
Goals
Turn on AILE-FLAP
mixing. Set rate to
100% for maximum
possible flap travel
with ailerons .Assign
to SWITCH C center.

4.3.12 SPOILER MIX (GLID):

Moves the spoiler by flipping the assigned switch and is used to make steep decent. SPOILER MIX
works linking with BUTTERFLY MIX.
Steps
Steps
Open AILE-FLAP submenu.
Activate the function
Set the rate (Ex:100% each
way)
Assign the SWITCH and
position.
Close
Inputs
to BASIC . again to ADVANCE
to AIL/RUD-MIX,
to MODE , to RUDD-AILE
to MIX , to ON
to RATE
RUDDER STICK ,
RUDDER STICK ,
Inputs
to BASIC .
to AILE-FLAP,
to MIX
to FLP1
AILERON STICK
AILERON STICK
Repeat above to set FLP2
to SW ,
to POSI
62
Radiolink Electronic Ltd
www.radiolink.com
to +25%
to +25%
again to ADVANCE
, to ON
, to 100%
, to 100%
to SwC
, to UP