RadioLink AT10 Instruction Manual page 20

GOALS of EXAMPLE
Where next?
MODEL submenu: includes three functions that manage model memory: MODEL SELECT , MODELCOPY and MODELNAME . Since
these functions are all related, and are all basic features used with most models, they are together in the MODEL submenu of
the BASIC menu.
GOAL:
Select Model #3.
N O T E : T h i s i s o n e o f s e v e r a l
functions for which the radio requires
Confirm proper modulation of new
model memory.
Where next?
STEPS
Set the second (low) rate throws and
exponential.
Optional: change dual rate switch
assignment. Ex: elevator to switch G
(AT10) or E (AT10) with 3 positions.
(Other functions you may wish to set up for your model.)
TRAINER p. 34.
Elevator-to-flap, Rudder-to-aileron, flap-to-elevator, and other programmable
mixes p. 53.
Retractable Gear, Flaps on a Switch, Smoke systems, kill switches, and other
auxiliary channel setups. p. 34.
MODEL SELECT : This function selects which of the 15 model memories in the
number. (Each model memory may be a different model type from the other
memories.)
NOTE: When you choose a new model in the MODEL SELECT function, if the new
model is set to the other modulation, you must cycle the transmitter power to change
screen to remind you. You are still transmitting on the other modulation until you
affect this change.
STEPS:
Open BASIC menu, then open MODEL
submenu.
Choose Model #3.
Close.
If 2.4G
modulation.
NAME the model: see p. 22.
Change MODEL TYPE (aircraft, heli, glider): see p. 23.
Utilize servo REVERSE : see p. 26.
Adjust END POINTs : see p. 27.
Set up IDLE-DOWN and THR-CUT for throttle management: see p. 28, 29.
20
INPUTS for EXAMPLE
C
Repeat steps above to set low rate.
C
Repeat steps above to set 3rd rate.
fly.
for 1 second.
if required to MODEL
to 3 .
for 1 second.
Are you sure? displays.
A to down position.
to D/R .
to SW . to G or E .
G or E to center position.
38,45.
INPUTS:
again.)
(If ADVANCE ,