End Point - RadioLink AT10 Instruction Manual

NOTE: THR-REV is a special function that reverses the entire throttle control, including moving the trim functionality to
the Stick's upper half. To use THR-REV , turn off the transmitter, hold down the MODE and END keys, turn on. CURSOR
DOWN to THR-REV and turn the DIAL to REV . Turn the transmitter off and back on. This change affects all models in the
radio.
GOAL of EXAMPLE:
Reverse the direction of the elevator
servo.
Where next?
End Point of servo travel adjustment ( END POINT , also called EPA): the most flexible version of travel adjustment
available. It independently adjusts each end of each individual servo's travel, rather than one setting for the servo that
affects both directions. Again, for CCPM helicopters, be sure to see SWASH AFR (see p. 73) prior to adjusting end points.
Examples:
• Adjust the throttle high end to avoid binding at the carburetor, and low end to allow for proper carburetor closure.

• END POINT

spoilers.
• Retract servos are not proportional. Changing END POINT will not adjust the servo.
END POINT adjusts only the individual servo. It will have no effect on any other servo that is operated in conjunction with
this servo via mix or preset programming such as FLAPERON , AILEVATOR , etc. This is so that each individual servo can be
the adjustments in that function's controls. For CCPM helicopters, adjust the total travel of the function, such as collective
pitch, in SWASH AFR .
Except with CCPM helicopters, always complete your servo reversing prior to
any other programming. If you use pre-built ACRO GLID functions that control
multiple servos, such as FLAPERON or V-TAIL , it may be confusing to tell whether
the servo needs to be reversed or a setting in the function needs to be reversed.
See the instructions for each specialized function for further details.
Always check servo direction prior to every flight as an additional
STEPS:
Open REVERSE function.
C h o o s e p r o p e r c h a n n e l a n d s e t
direction. (Ex: ELE REV )
Close.
Adjust servo travel with END POINT : see p. 27.
Set up trainer functions: see p. 34.
Adjustability:
• Can set each direction independently.
• Ranges from 0% (no servo movement at all) to 140%. At a 100% setting, the
throw of the servo is approximately 40° for channels 1-4 and approximately 55
° for channels 5-8.
• Reducing the percentage settings reduces the total servo throw in that direction.
27
INPUTS:
for 1 second.
C to REVERSE .
C to ELE .
to REV .
D/R , EXP ): see p. 30.
33.
(If ADVANCE , again.)
for 1 second.
FLAPERON , make