RadioLink AT10 Instruction Manual page 21

MODEL COPY
The name of the model memory you are copying into is displayed for clarity.
Data cannot be converted from 8U or 9Z memory types.
Examples:
• Start a new model that is similar to one you have already programmed.
• Copy the current model data into another model memory as a backup or before experimenting with new settings.
in extreme wind; airplane model at extreme altitudes).
GOAL of EXAMPLE:
Copy model 3 into model 5.
N O T E : T h i s i s o n e o f s e v e r a l
functions for which the radio requires
Where next?
*Radio emits a repeating "beep" and shows progress on screen as the model memory is being copied. Note that if the power switch is turned off prior
to completion, the data will not be copied.
Notes:
• Any data in the model copied to will be written over and lost, including name,
type and modulation. It cannot be recovered.
• With the trainer FUNC mode it is not necessary to have the student radio contain
the setup of the aircraft. See TRAINER , p. 34
STEPS:
Open the BASIC menu, then open MODEL
submenu.
Confirm you are currently using the
proper model memory. (Ex: 3)
Go to MODEL COPY and choose the
model to copy into. (Ex: 5)
Close.
SELECT the copy you just made: see p. 20.
Rename it (it is currently named exactly the same as the model copied): see p. 22.
21
.
INPUTS:
for 1 second.
C to MODEL .
If SELECT does not indicate 3 , use MODEL
SELECT , p. 20.
C to COPY .
for 1 second.
Are you sure? displays.
(If ADVANCE , again.)
to 5 .
*