RadioLink AT10 Instruction Manual page 54

LINK ON , mixing is applied to both CH2 and CH4.
MASTER SLAVE
FLAP ELEV
•Trim: master's trim affects slave. Not displayed if master is not CH 1-4, because 5-9 have no trim. Ex: two rudder servos.
With TRIM OFF , rudder trim would bind the two servos. TRIM ON resolves this.
• On/off choices:
• SWITCH: Any of the positions of any of the 8 switches may be used to activate a mix. Up&Cntr , Cntr&Dn options
allow the mix to be ON in 2 of the 3 positions of a 3-position SWITCH.
• NULL : No SWITCH can turn this mix OFF . This mix is active at all times.
• LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW : See p. 26.
• STk-THR
doors) mix to open gear doors at idle, which is only active if throttle is below half.
MASTER SLAVE
OFST AUX2
• Rate: the percentage of the slave's range it will move upon maximum input from the master channel. Ex: RUDDER -
AILERON
MASTER SLAVE
RUDD AILE
• Offset: Offsets the slave's center relative to the master. Ex: Smoke valve opens wider per throttle servo position when
smoke SWITCH is ON . Smoke servo's neutral is moved down from THROTTLE STICK center to the bottom.
MASTER SLAVE
THRO AUX2
LINK TRIM
ON OFF
THROTTLE STICK
LINK TRIM
OFF NO
LINK TRIM
OFF OFF
LINK TRIM
OFF OFF
SWITCH POSITION
ANY
NULL
SWITCH POSITION
STK-THR Stick at 1/2,
for 1 sec.
SWITCH POSITION
ANY
NULL
SWITCH POSITION
E DOWN
54
RATE OFFSET
5% 0
OFST -to-(gear
RATE OFFSET
100% 0
RATE OFFSET
50% 0
RATE OFFSET
100% 100%