RadioLink AT10 Instruction Manual page 22

MODEL NAME : assigns a name to the current model memory. By giving each model a name that is immediately recognizable,
a crash.
NOTE: When you COPY one model memory over another, everything is copied, including the model's name. Similarly, if
you change MODEL TYPE or do a MODEL RESET , the entire memory is reset, including MODEL NAME
want to do after you COPY a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
GOAL of EXAMPLE:
Name model 3 "Cap-232_" (where the
underline represents a blank space.)
Where next?
Adjustability and values:
•Up to 9 characters long.
• Each character may be a letter, number, blank, or a symbol.
• The default names assigned by the factory are in MODEL-xxx format
( MODEL-001
STEPS:
Open MODEL submenu.
Confirm you are currently using the
proper model memory. (Ex: 3)
G o t o NAME a n d c h a n g e t h e f i r s t
character. (Ex: M to C)
Choose the next character to change.
Repeat the prior steps to complete
naming the model.
Close.
Change the MODEL TYPE to glider or helicopter: see p. 23.
Utilize servo REVERSE : see p. 26.
Adjust servo travel with END POINT : see p. 27.
22
INPUTS:
for 1 second.
(If ADVANCE ,
C to MODEL .
If SELECT does not indicate 3 ,
perform MODEL SELECT , p. 20.
C to M to C .
C
to a
(note: lower case is available)
Repeat.
D/R , EXP ): see p. 30.
again.)