Password - Honeywell MX9 User Manual

Password

Start > Settings > Control Panel > Password
Use this panel to set MX9 user access to control panels and power up password properties.
Important: This password must be entered before performing a Load Factory Defaults on the Registry control panel.
Contact Technical Assistance
this password protection or perform a Load Factory Defaults.
Setting
Password
Enter password at Power On
Enter password at Remote Desktop Screen
Saver
Enter the password in the Password text box, then press Tab and type the password again to confirm it.
Enable the power-on check box and, if desired, the screensaver check box. A changed/saved password is in effect immedi-
ately.
• The password and password settings are saved during a warm boot and a cold boot.
• The screensaver password affects the Remote Desktop screensaver only.
• After a password is assigned and saved, each time a Settings > Control Panel option is selected, the user will be
required to enter the password before the Control Panel will open.
• The screensaver password is the same as the power-on password. They are not set independently.
• A screensaver password cannot be created without first enabling the "Enable password protection at power-on" check
box.
• The screensaver password is not automatically enabled when the "power-on" check box is enabled.
5 - 48
(page 15-1) if entering a power-on or screen saver password does not allow you to disable
Default
Blank
Disabled
Disabled