Inserting A Battery Into The Charging Pocket; Removing The Battery From The Charging Pocket; Interpreting The Charging Pocket Leds - Honeywell MX9 User Manual

Inserting a Battery into the Charging Pocket

It is important that battery packs are inserted into the charging pocket correctly. Inserting the battery incorrectly could result
in damage to the battery pack or the charger.
Do not "slam" the battery pack into the charging pocket. Damage may result.
1. When preparing the battery pack for insertion into the battery charging pocket, hold the battery with its four charging
contacts in line with the charging contacts in the charging pocket.
2. Aim the retaining catch towards the back of the charger.
3. Push the locking tab towards the back of the battery charging pocket until it stays in place.
4. Place the battery in the charging pocket, making sure the tab at the top of the battery pack fits into the slot at the top end
of the charging pocket.
5. With a hinging motion, slip the battery down into the charging pocket until the locking tab clicks into place and the
battery pack is secure in the charging pocket.

Removing the Battery from the Charging Pocket

1. Push the locking tab away from the battery. The battery will pop up slightly.
2. Grasp the battery and with a hinging motion, lift it out of the charging pocket.

Interpreting the Charging Pocket LEDs

The status of the charge operation is indicated by the color of the LED for each charging pocket.
RED Continuous - on any charge pocket
Continuous red means the battery pack is charging.
RED FLASHING - on all charge pockets
Battery charger fault or failure.
GREEN - on any charge pocket
Continuous green means the battery pack charge is complete - Battery is Ready.
YELLOW - on any charge pocket
Continuous yellow / amber means the battery pack temperature is out of range. The charging pocket is in standby mode
while the pocket waits for the battery pack to warm up or cool down.
NO LIGHT - on any charge pocket
No light on a charge pocket means there is no battery pack installed ,
• or the battery pack in the pocket is not fully inserted,
• or a defective or damaged battery pack is installed,
• or the charger is defective or damaged. Refer to Battery Charger Help (page 12-6).
12 - 5