Vehicle Cradle Led; Docking The Mx9 In A Vehicle Mounted Cradle - Honeywell MX9 User Manual

Vehicle Cradle LED

The cradle LED is located at the front center of the vehicle cradle.
When Cradle LED is ...
Off
Green

Docking the MX9 in a Vehicle Mounted Cradle

Note: Do not put the MX9 into the vehicle cradle until the cradle is securely fastened to the vehicle.
1. The MX9 is docked in the vehicle cradle by sliding the base of the MX9 down into the cradle docking bay until the con-
nector at the base of the MX9 clicks into place with the charging/communication connector at the bottom of the docking
bay.
2. If the cradle is connected to a power source, the Docked LED illuminates.
3. Firmly press the MX9 backwards until the MX9 mates with the pins and the release mechanisms snap forward, securing
the MX9 in the vehicle cradle.
Do not slam the MX9 into the cradle pocket. Damage to the cradle and MX9 components may occur. If the vehicle cradle or
MX9 is damaged, it must be removed from service and repaired before placing it into service again.
13 - 24
It means ....
MX9 is docked. Cradle does not have power.
MX9 is not docked. Cradle may have power. Check the power connection at
the back of the cradle.
No power applied to the cradle.
MX9 is docked and external power is connected.