Honeywell MX9 User Manual page 153

Message
Timeout looking for app window
ToUser after admin, not at boot
ToUser after admin-app still open
ToUser after admin-no app or cmd line
change
Unable to move desktop
Unable to move taskbar
Unhook taskbar wndproc failure
Unhook wndproc failure
Unhooking taskbar
Unhooking wndproc
WM_SIZE adjusted
X after Ctrl+L
Ret from password <#>
Decrypt data len <#>
Window handle to enumwindows=%x
WM_WINDOWPOSCHG adjusted=%x
Explanation and/or corrective action
After the application is launched, AppLock must wait
until the application has initialized itself before
proceeding. The application did not start
successfully and AppLock has timed out.
The user mode switch is attempted when the device
boots and after the administrator presses the
hotkey. The mode switch is being attempted after a
hotkey press.
The switch to user mode is being made via a hotkey
press and the administrator has left the application
open and has not made any changes in the
configuration.
If user mode is being entered via a hotkey press, the
administrator may have left the configured
application open. If so, AppLock does not launch the
application again unless a new application or
command line has been specified; otherwise, it just
locks it.
The desktop is moved when switching into user
mode. This prevents them from being visible if the
application is exited and restarted by the timer. This
error does not affect the screen mode switch;
processing continues.
The taskbar is moved when switching into user
mode. This prevents them from being visible if the
application is exited and restarted by the timer. This
error does not affect the screen mode switch;
processing continues.
AppLock could not remove its control of the taskbar.
This error does not affect AppLock processing
AppLock could not remove the hook that allows
monitoring of the application.
In administration mode, the taskbar should return to
normal operation, so AppLock's control of the
taskbar should be removed.
When the administrator leaves user mode, the
device is fully operational; therefore, AppLock must
stop monitoring the locked application.
This message denotes that AppLock has readjusted
the window size.
Processing the backdoor entry.
Return value from password dialog.
Length of decrypted password.
The window handle that is passed to the
enumeration function. This message can be used
by engineering with other development tools to
trouble shoot application lock failures.
Output the window size after it has been adjusted by
AppLock
Level
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
6 - 19