Honeywell MX9 User Manual page 17

CE Mark
The CE marking indicates compliance with the following directives:
• 1995/5/EC R&TTE
• 2011/65/EU RoHS (Recast)
In addition, complies to 2006/95/EC Low Voltage Directive, when shipped with recommended power supply. European contact::
Hand Held Products Europe BV
Nijverheidsweg 9-13
5627 BT Eindhoven
The Netherlands
Honeywell shall not be liable for use of our product with equipment (i.e., power supplies, personal computers, etc.) that is not CE
marked and does not comply with the Low Voltage Directive.
RF Notices
This device can contain transmitter Module(s) FCC ID: DDZLXE4830P, KDZBT001, E09HHSR3. This
equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment under 47 CFR
2.1093 paragraph (d)(2).
FCC / EU RF Exposure Guidelines
Safety Information
The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio
devices.
Reducing RF Exposure - Use Properly
It is advisable to use the device only in the normal operating position.
Handheld Devices
This device was tested for typical body-worn operation. Use only Honeywell tested and approved accessories to ensure FCC
Compliance. The use of third-party accessories may not comply with FCC RF exposure compliance requirements, and should
be avoided. To comply with FCC RF exposure requirements, this device must be operated in the hand with a minimum
separation distance of 2.5 cm (0.9842 inch) or more from a person's body or with the following body-worn accessories as shown
in the applicable section of the manual, see
- MX9420HOLSTER
- MX9423HOLSTER
- MX9410CASE. Shoulder strap is not approved with use with WWAN configurations.
Bluetooth
Class II
Honeywell Scanning & Mobility Product Environmental Information
Refer to www.honeywellaidc.com/environmental
Body Worn Accessories (page 2-14).
for the RoHS / REACH / WEEE information.
1 - 3