Hand Strap; End User License Agreement; Inserting Or Replacing The Battery Pack; Insert/Replace Battery - Honeywell MX9 User Manual

Hand Strap

End User License Agreement

When a new MX9 starts up a EULA is displayed on the touch screen. It remains on the screen until the Accept or Decline button
is tapped with a stylus.
• Tap the Accept button to accept the EULA terms and the MX9 continues the startup process. The EULA is not presented to
the user again.
• Tap the Decline button to decline the EULA and the MX9 will reboot. It will continue to reboot until the Accept button is tapped
with the stylus.
Note: The EULA will be presented after any operating system upgrade or re-installation, including language-specific operating
systems.

Inserting or Replacing the Battery Pack

Warning: Never remove or replace any battery in a hazardous location.
The MX9 will not function unless the battery pack is in place and securely latched.
Be sure to place the unit in Suspend Mode before removing the battery. Failing to properly place the device in Suspend mode
will result in a loss of all unsaved data.
The main battery is located in a compartment on the back of the unit. The battery case serves as the back cover for the battery
well of the MX9.
An MX9 will retain data, while the main battery is removed and replaced with a fully charged main battery, for 5 minutes.
Important: When the internal battery power is Low or Very Low connect the AC adapter to the MX9 before replacing the main
battery.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the battery is not connected to the
MX9, any dust or moisture that enters the battery well or connector may transfer to the battery/well terminals, potentially
causing damage.
Warning. Only use Honeywell batteries as replacements: MX9380BATTERY 161888-0001 or 161915-0001 (Low Temperature)

Insert/Replace Battery

To insert the main battery, complete the following steps:
1. Detach the bottom hook of the hand strap (if installed).
2. Tilt the end (with the terminals) of the fully charged battery pack into the upper end of the battery compartment, and
firmly press the other end until it is fully inserted into the battery compartment.
3. Push down on the battery until the retaining clip clicks into place.
4. Replace the hand strap clip in its holder (if installed).
1. Hand strap connector, upper
2. Stylus holder on Hand strap
3. Hand strap connector, lower
2 - 7