Keymap Tab; Remap A Single Key; Remap A Key To A Unicode Value; Remap A Key Sequence - Honeywell MX9 User Manual

KeyMap Tab

Assign settings by tapping radio buttons and selecting keys from the drop down boxes. Tap the OK button when fin-
ished. The changes take effect immediately.

Remap a Single Key

1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select the value from the remapped key from the Remapped Key pulldown list.
4. Tap OK to save the result and close the Keypad Control.

Remap a Key to a Unicode Value

1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select Unicode from the Remapped Key pulldown list.
4. There are two Unicode text boxes located on the lower part of this tab. Enter the Unicode value in the left
textbox and the Unicode character is displayed in the right textbox.
5. Tap OK to save the result and close the control panel.

Remap a Key Sequence

1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select Key Sequence from the Remapped Key pulldown list.
4. Select the first key for the multiple key sequence from the pulldown list.
5. Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box. Repeat this
step until all keys desired have been added to the key sequence. If necessary, use the Clear button to erase all
entries in the Key Sequence box.
6. Tap OK to save the result and close the Keypad Control.
Note: A key can only be used once in a multiple key sequence. For example, an F1 key added to a key sequence
means an F1 key cannot be used again in the same key sequence.
5 - 32