Honeywell MX9 User Manual page 243

Parameter Default
Radio Mode BG radio:
BG Rates Full
Or
A radio:
BGA Rates Full
It is important the Radio Mode parameter correspond to the Access Point (AP) to which the device is to connect. For
example, if this parameter is set to G rates only, the MX9 may only connect to APs set for G rates and not those set for
B and G rates.
The options for the Radio Mode parameter should be set, based on the antenna configuration, as follows:
Antenna Configuration
A Main and BG Main
A Main and A Aux
BG Main and BG Aux
Contact Technical Assistance
Explanation
Specify 802.11a, 802.11b and/or 802.11g rates when communicating
with the AP. The options displayed for this parameter depend on the type
of radio installed in the mobile device.
Options:
• B rates only (1, 2, 5.5 and 11 Mbps)
• BG Rates Full (All B and G rates)
• G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
• BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps)
• A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
• ABG Rates Full (All A rates and all B and G rates with A rates
preferred)
• BGA Rates Full (All B and G rates and all A rates with B and G rates
preferred)
• Ad Hoc (when connecting to another client device instead of an AP
Default:
• BG Rates Full (for 802.11b/g radios)
• BGA Rates Full (for 802.11a/b/g radio)
Note: BG radio only - Previous SCU versions may have the default set
as BG Rates Full. Depending on the SCU version, either BG
Optimized or BG subset is the default.
Radio Mode
ABG Rates Full
BGA Rates Full
A Rates Only
B Rates Only
G Rates Only
BG Rates Full
BG Subset
(page 15-1) if you have questions about the antenna(s) installed on your MX9.
10 - 9