Rear Hatch Lock Rod Removal - Daewoo Nubira Owner's Manual

TECHNICAL SERVICE BULLETIN
TECHNICAL SERVICE BULLETIN
Bulletin No.:
TSB-002-98
Model(s): 1998-99 Nubira 5-Door
Date: November 25, 1998
VIN Range: See Attached
For some Nubira 5-Door models, it is possible that
the alarm may be triggered when opening the rear
hatch with the key. If the key is rotated slowly, it is
possible that the rear latch could be released before
the lock switch disables the alarm system. To correct
this condition, Daewoo has developed an updated
rear hatch lock rod which is 5 mm shorter than the
original rod.
A supply of updated lock rods has been shipped to
your location and are available for customer
complaints/concerns.
All applicable Store stock units should be immediately updated with the new lock rod.
Affected customer vehicles, demonstrators, DCA vehicles, etc. should be updated as they
come in for periodic service and/or repairs regardless if a complaint has been made.
A list of applicable Nubira 5-Door Vehicle Identification Numbers (VIN's) has been attached
for your reference.
REAR HATCH LOCK ROD REMOVAL / INSTALLATION INSTRUCTIONS
Lock Rod Removal:
1. Raise the rear hatch to its fully opened position.
2. Remove the rear hatch inner trim panel by
removing and retaining the four (4) screws and
three (3) trim panel clips.
√
General Manager
Circulate To:
√
Service Manager
Description:
Group:
Reference:
Prod. Dates:
√ √
Technician(s)
√ √
Service Advisor
Rear Hatch Lock Rod
Body
N/A
N/A
"New"
Lock Rod
Rear Hatch
Inner Trim Panel
Body Shop Manager
Parts Manager
"Old"
Lock Rod