Powertrain Control Module/Engine Control Module Removal - Daewoo Nubira Owner's Manual

DAEWOO V–121 BL4
ENGINE CONTROLS 1F – 399
2. Install the timing belt front cover, the crankshaft
pulley, the accessory drive belt, and the air filter.
Refer to Section 1C, DOHC Engine Mechanical.
3. Connect the sensor electrical connector.
4. Install the engine cover.
5. Connect the negative battery cable.
POWERTRAIN CONTROL MODULE/
ENGINE CONTROL MODULE
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the right side kick panel. Refer to Section
9G, Interior Trim.
3. Disconnect the powertrain control module
(PCM)/engine control module (ECM) retaining clip
from the PCM/ECM mounting base.
4. Remove the retaining clip lower end from the
mounting base.
5. Remove the PCM/ECM from the mounting base.
6. Disconnect the PCM/ECM connectors from the
PCM/ ECM.