Daewoo Nubira Owner's Manual page 736

Description
Fuel Level Sensor Procedures
Installation
9. Temporarily wrap the new Fuel Level Sensor
wire terminals with electrical tape.
10. Route the wire through the groove at the bottom
of the Fuel Level Sensor as you route it around
to the back of the Fuel Level Sensor Body.
Note: Failure to properly route the wire in the
groove may cause the wire to be
damaged as the Fuel Level Sensor is
installed.
11. Guide the Fuel Level Sensor Body onto the
retaining rail on the Fuel Pump Module Body.
Slide it fully into place on the retaining rail. An
audible "click" will be heard as it locks into it's
proper position.
Note: Failure to properly lock the Fuel Level
Sensor into place will affect its accuracy.
12. Route the Fuel Level Sensor wires through the
built-in tube in the Fuel Pump Module Body.
13.Route the Fuel Level Sensor wires through the
retaining hook on top of the Fuel Pump
Module Body.
14.Remove the electrical tape, then insert the
Fuel Level Sensor Terminals into the Fuel
Pump Module Sub-harness Electrical
Connector. Ensure that the terminals are
properly reinstalled (as noted previously) and
that the correct wire colors are in their proper
connector location. Also, verify that the
terminals are locked into position by gently
tugging on the wires after installation.
Note: The forward-most edge of the beveled
terminal face should be oriented
towards the "outboard" edges of the
terminal housing.
15. Once the terminals are properly positioned,
reinstall the secondary terminal lock into the
connector. Reconnect the sub-harness
connector to the Fuel Pump Module Mounting
Flange Connector.
August, 2001
Groove
Fuel Level Sensor Wires
Fuel Level Sensor Wires
Install Terminals
Secondary Terminal Lock
Page
5 of 7
Sub-Harness
Electrical Connector
Mounting Flange
Connector