Evaporative Emission Canister Purge Solenoid Removal; Evaporative Emission Canister Purge Solenoid Installation; Crankshaft Position Sensor Removal - Daewoo Nubira Owner's Manual

1F – 396IENGINE CONTROLS
EVAPORATIVE EMISSION CANISTER
PURGE SOLENOID
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the Evaporative (EVAP) Emission can-
ister purge solenoid connector.
3. Disconnect the vacuum hoses from the EVAP emis-
sion canister purge solenoid.
4. Remove the EVAP emission canister purge sole-
noid bracket bolt from the intake manifold.
5. Unclip the EVAP emission canister purge solenoid
from the mounting bracket.
Installation Procedure
1. Attach the EVAP canister purge solenoid to the
mounting bracket.
2. Install the EVAP canister purge solenoid and the
mounting bracket to the intake manifold with the
bracket bolt.
Tighten
Tighten the evaporative emission canister purge
sole–noid bracket bolt to 44 lb–in (5 NSm).
3. Connect the vacuum hoses to the EVAP emission
canister purge solenoid.
4. Connect the EVAP emission canister purge sole-
noid connector.
5. Connect the negative battery cable.
CRANKSHAFT POSITION SENSOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the power steering pump, if equipped. Re-
fer to Section 6B, Power Steering Pump.
3. Remove the A/C compressor, if equipped. Refer to
Section 7B, Manual Control Heating, Ventilation,
and Air Conditioning System.
4. Remove the rear A/C compressor mounting bracket
bolts and the rear A/C compressor mounting brack-
et, if equipped.
5. Remove the accessory mounting bracket by remov-
ing the bolts.
DAEWOO V–121 BL4