Daewoo Nubira Owner's Manual page 717

9U – 10ICRUISE CONRTOL SYSTEM
Step
42
1. Turn the ignition OFF.
2. If the vehicle has amanual transaxle, discon-
nect the VSS electrical connector.
3. If the vehicle has an automatic transaxle, dis-
connect the electrical connector from the trans-
axle output shaft sensor.
S If the vehicle has a manual transaxle, use an
ohmmeter to check continuity between the DK
GRN/WHT wire at the VSS and terminal 10 of
the cruise control actuator connector.
S If the vehicle has an automatic transaxle,
check the continuity of the following wires:
– The YEL wire between cruise control ac-
tuator connector terminal 10 and VSS con-
nector terminal A.
– The PPL wire between cruise control ac-
tuator connector terminal 5 and VSS con-
nector terminal B.
Does the ohmmeter indicate the specified value
when checking the wire(s) between the cruise con-
trol module and the VSS, for vehicles with amanual
transaxle, or the output shaft sensor, for vehicles
with an automatic transaxle?
43 Repair the open circuit between the cruise control
actuatorconnector terminal 10 and theVSS, for ve-
hicles with amanual transaxle, or the output shaft
sensor forvehicles with an automatic transaxle.
Is the repair complete?
44 Replace the cruise control actuator.
Is the repair complete?
Action Value(s) Yes
[ 0 W
Go to Step 44
System OK
System OK
No
Go to Step 43
DAEWOO V–121 BL4