Grabbing (Chattering); Rattling (Transaxle Click); Release Bearing Noise With Clutch Fully Engaged; Pedal Stays On Floor When Disengaged - Daewoo Nubira Owner's Manual

Check for a burned or a glazed facing caused by oil on the
facing.
Check for worn splines on the input shaft.
Check for a warped pressure plate or a warped flywheel.
Check for burned or smeared resin on the flywheel or the
pressure plate.
Check for weak retracting springs.
Check for a loose release fork.
Check for oil in the driven plate damper.
Check for a damaged driven plate damper spring.
Check for the driver improperly operating the vehicle.
Check for a binding release bearing.
Check for an improperly installed release lever.
Check for a weak linkage return spring.
Check for a worn release bearing.
Check for an improperly installed release lever.
Check for binding in the linkage or the release bearing.
Check for weak pressure plate springs.
Check for binding in the linkage.
Check for a worn driven plate.
DAEWOO V–121 BL4

Grabbing (Chattering)

Checks

Rattling (Transaxle Click)

Checks

Release Bearing Noise with Clutch Fully Engaged

Checks
Checks

Pedal Stays on Floor When Disengaged

Checks
Hard Pedal Effort
Checks
Correct the leak at its source and install a new clutch disc.
Replace the worn input shaft.
Replace the warped pressure plate or the warped fly-
wheel.
Sand off the burned or smeared resin if it is superficial.
Replace any burned or heat–checked parts.
Replace the pressure plate.
Remove and reinstall the release fork properly.
Correct the cause of the oil leak and replace the driven
disc.
Replace the driven disc.
Correct the driver's operation of the vehicle as necessary.
Clean and re–lubricate the release bearing. Inspect the re-
lease bearing for burrs and nicks.
Remove and reinstall the release lever properly.
Replace the weak linkage return spring.
Noisy
Replace the worn release bearing.
Remove and properly reinstall the fork shaft. Very lightly
lubricate the fork fingers at the release bearing with wheel
bearing grease.
Lubricate and free–up the binding linkage or the release
bearing.
Replace the pressure plate.
Lubricate and free–up the binding linkage.
Replace the worn driven plate.
CLUTCH 5C0 – 3
Action
Action
Action
Action
Action
Action