Daewoo Nubira Owner's Manual page 262

DAEWOO V–121 BL4
AUTOMATIC TRANSAXLE DRIVE AXLE 3A – 5
7. Remove the tie rod nut.
Notice : Use only the recommended tool for separating
the tie rod from the knuckle/strut assembly. Failure to use
the recommended tool may cause damage to the knuckle/
strut assembly.
8. Separate the tie rod end using the ball joint separa-
tor KM–507–B.
9. Push the drive axle shaft from the wheel hub.
Important : Support the unfastened end of the drive axle.
Do not allow the drive axle to dangle freely from the trans-
axle for any length of time after it has been removed from
the wheel hub.
Important : Place a drain pan below the transaxle to catch
the escaping fluid. Cap the transaxle drive opening after
the drive axle has been removed to keep the fluid in and
any contamination out.
10. Remove the drive axle from the transaxle using the
axle shaft remover KM–460–A.