Engine Coolant Temperature Sensor Removal; Engine Coolant Temperature Sensor Installation - Daewoo Nubira Owner's Manual

DAEWOO V–121 BL4
ENGINE COOLING 1D – 17
7. Connect the transaxle cooler pipes to the lower ra-
diator tank, if equipped.
8. Install the transaxle pipe and support clamp to the
radiator with a bolt.
9. Connect the surge tank hose to the radiator.
10. Secure the surge tank hose with a hose clamp.
11. Connect the upper radiator hose and the lower ra-
diator hose to the radiator.
12. Secure each hose with a hose clamp.
13. Install the main and the auxiliary cooling fans. Refer
to "Electric Cooling Fan – Main or Auxiliary" in this
section.
14. Refill the engine cooling system. Refer to "Draining
and Refilling the Cooling System" in this section.
15. Connect the negative battery cable.
ENGINE COOLANT TEMPERATURE
SENSOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Drain the coolant to a level below the engine cool-
ant temperature sensor.
3. Disconnect the electrical connector from the engine
coolant temperature sensor.
4. Remove the temperature sensor from the exhaust
gas recirculation (EGR) valve mounting adapter.
Installation Procedure
1. Install the engine coolant temperature sensor into
the threaded hole in the EGR valve mounting
adapter.
Tighten
Tighten the engine coolant temperature sensor (2.0L
DOHC) to 10 NSm (89 lb–in).
2. Connect the electrical connector to the engine cool-
ant temperature sensor.
3. Refill the engine cooling system. Refer to "Draining
and Refilling the Cooling System" in this section.
4. Connect the negative battery cable.