Printer Connection Method (Lpd/Raw); Windows 98/Me - Canon CLC3220 Network Manual

Printer Connection Method (LPD/Raw)

The following is the procedure for specifying the port setting.

Windows 98/Me

■ Installing a New Driver
1
Install the driver.
Install the driver according to the following procedures indicated in the manual for each driver:
• If you want to use the PCL printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the PCL Driver
Guide.
• If you want to use the PS printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the PS Driver
Guide.
• If you want to use the UFR printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the UFR Driver
Guide.
• If you want to use the fax driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the Fax Driver
Guide.
IMPORTANT
If your computer fails to transmit data to the printer during installation of the driver, when the error
message appears, click [No] ➞ set the byte count mode to off.
NOTE
• The print application will be LPD and the print queue will be set to <LP> if the driver has been
installed according to the above procedures.
• This machine enables you to specify print queues other than <LP>. For details on print queues
and instructions on how to change the settings, see "Changing the Port after Installing the
Driver," on p. 3-36.
Setting Up a Computer for Printing/Sending a Fax (Windows/UNIX)
3
3-35