Canon CLC3220 Network Manual page 204

Cause 3
Remedy
Unable to Send Data/Share Files (NetWare)
Cause 1
Remedy
NOTE
If data cannot be sent or file sharing will not work after you do the above, consult your network manager.
Cause 2
8
Remedy
8-10
Data Sending/File Sharing Problems and Remedies
The machine was turned to OFF while sending data to the FTP server, and when the
machine was turned back to ON, it attempted to resend the data. (If a Windows NT/2000/XP/
Server 2003 FTP server is being used.)
If power to the machine is turned to OFF while data is being sent to the FTP server, the FTP
server may hold the data in a writing-in-progress state. Therefore, this data cannot be
overwritten even when the machine reconnects and sends the same data again. Stop the
FTP server temporarily and delete the data that has not finished sending, so it can be sent
again.
File sharing settings for the NetWare file server are incorrect. (In Bindery Mode.)
Check the following settings:
• Use your computer to log in to NetWare file server.
From Windows Explorer, double-click [Entire Network] ➞ check that the NetWare server
you want to share is listed there.
You can also check for the NetWare server as follows: On the [Start] menu, point to [Find] ➞
click [Computer] ➞ enter the name of the server you want to share ➞ check that the server
is on the network. (This server name will be [Host Name] entered when you set up the
recipient settings.)
• Open the server ➞ open the folder for file sharing. (The path to this folder will be [File Path]
entered when you set up the recipient settings.)
• Check that files can be written to this folder.
File sharing settings for the NetWare file server are incorrect. (In NDS Mode.)
Check the following settings:
• Log in as a user with Admin (or equivalent authority).
From Windows Explorer, double-click [Entire Network] ➞ check that the NetWare server
you want to share is listed there.
You can also check for the NetWare server as follows: On the [Start] menu, point to [Find] ➞
click [Computer] ➞ enter the name of the server you want to share ➞ check that the server
is on the network.
• Start the NWADMIN for this server. If [Root] is displayed at the upper left corner of the
screen, the layer below it is the context. If [Root] is not displayed, go to the [View] menu ➞
select [Go Up a Level] to change to the display below [Root]. (This context will be the value
entered to the right side of the expression "o=" when you set up [Host Name] of the
recipient.)