Netbios Network Setup Procedures - Canon CLC3220 Network Manual

NetBIOS Network Setup Procedures

To use a NetBIOS network, it is necessary to perform the following procedures.
1
2
5
3
IMPORTANT
• If you are using the optional Color Network Printer Unit, for steps 1 and 2, see the manual provided with
the optional Color Network Printer Unit.
• It is recommended that the network manager perform steps 1 and 3 above.
• The only base protocol supported by a NetBIOS network is TCP/IP. (SMB is used as the print
application.) NetBEUI is not supported with the machine.
• Use the control panel or NetSpot Device Installer if you configure the TCP/IP settings for the first time.
After configuring the settings, you can change the content by using a web browser (Remote UI) or a web
browser (NetSpot Console).
5-2

NetBIOS Network Setup Procedures

Protocol Settings (See "Protocol Settings," on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
A web browser (Remote UI)
•
A web browser (NetSpot Console) (Canon utility)
Computer Settings for Printing (See "Setting Up a Computer for Printing/Sending a Fax,"
on p. 5-10.)
Specify the settings of each computer you use for printing or sending a fax. (To print or send a fax from a computer, the optional
equipment must be installed. For the equipment needed, see "Optional Equipment and System Environment Requirements," on
p. 1-2.)
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 5-16.)
Specify the settings of the computer receiving data sent from the machine. (To send data, the optional equipment must be
installed. For the equipment needed, see "Optional Equipment and System Environment Requirements," on p. 1-2.)