Printer Connection Method - Canon CLC3220 Network Manual

Printer Connection Method

Install the driver and specify the port for the machine to use to print or send a fax. Follow the
instructions below.
NOTE
If Windows NT/2000/XP/Server 2003 is on your network, the following procedure enables you to set up
a print server for more efficient management of network printers. Once a print server is set up, print jobs
can be managed by the print server. Also, by setting up an alternate driver for the print server, printer
drivers can be installed in each computer via the network.
For instructions on how to set print servers, see the following procedures indicated in the manual for
each driver:
- If you want to use the PCL printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting Started," in the PCL
Driver Guide.
- If you want to use the PS printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting Started," in the PS
Driver Guide.
- If you want to use the UFR printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting Started," in the UFR
5
Driver Guide.
- If you want to use the fax driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting Started," in the Fax
Driver Guide.
1
5-14
Setting Up a Computer for Printing/Sending a Fax
Check the settings for both <RX/Print Range> and <Setting/Browsing
Range> in [IP Address Range Settings] to see whether the IP address
of the computer in which a driver is to be installed is permitted. (See
step 21 in "TCP/IP Settings," on p. 3-4.)
IMPORTANT
• If the settings for both <RX/Print Range> and <Setting/Browsing Range> in [IP Address Range
Settings] do not permit the IP address, you cannot install a driver.
• If the IP address of the computer is beyond the range of the permitted addresses for <RX/Print
Range> after installing a driver, you cannot print from the computer.