Canon CLC3220 Network Manual page 44

2
11
12
13
The Token Ring settings are complete.
2-16
Interface Settings
IMPORTANT
• If you use an LAA, be sure to set a valid LAA. The machine will not work normally if you use the
default address without changing it.
• Either the MAC address or LAA is required as the Token Ring node address. If you do not set any
LAA, the MAC address is used as the node address.
NOTE
The MAC address displayed on the touch panel display is unique to the Token Ring board, and is
set independently of the MAC address of the Ethernet board.
Confirm the settings you specified ➞ press [OK].
The display returns to the Network Settings screen.
Press [Done] repeatedly until the Additional Functions screen closes.
Restart the machine.
❑
Turn OFF the machine, wait at least 10 seconds, and then turn it ON again.
NOTE
For instructions on how to turn ON/OFF the machine, see Chapter 1, "Before You Start Using
This Machine," in the Reference Guide.