Connecting To A Network; Using Ethernet - Canon CLC3220 Network Manual

Connecting to a Network

The machine supports TCP/IP, AppleTalk, and NetWare, which enables it to be used by
Windows, Macintosh, UNIX, and Linux computers. It also has a 10Base-T/100Base-TX
connector and optional Token Ring connector that can be used on most LANs.

Using Ethernet

Connect the machine's RJ-45 connector to a hub port using a Category 5 twisted pair LAN
cable.
2
IMPORTANT
• The machine supports both Ethernet and Token Ring networks; however, you cannot use the machine
to connect to both types of network at the same time.
• If the machine has both network boards (Ethernet and Token Ring) installed, you need to remove the
Token Ring Board. For more information, consult your local authorized Canon dealer.
• You cannot use the machine as a repeater, bridge, or gateway.
• If two or more machines are on an AppleTalk network, they should be switched 'on' 10 seconds or more
apart.
2-4
Connecting the Machine to a Computer or Network
PC with
100Base-TX Connector
Hub
PC with
10Base-T Connector
Ethernet Cable