3
3
■ Changing the Port after Installing the Driver
1
3-42
Setting Up a Computer for Printing/Sending a Fax (Windows/UNIX)
Install the driver.
Install the driver according to the following procedures indicated in the manual for each driver:
• If you want to use the PCL printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the PCL Driver
Guide.
• If you want to use the PS printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the PS Driver
Guide.
• If you want to use the UFR printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the UFR Driver
Guide.
• If you want to use the fax driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the Fax Driver
Guide.
NOTE
• The print application will be LPD and the print queue will be set to <LP> if the driver has been
installed according to the above procedures.
• This machine enables you to specify print queues other than <LP>. For details on print queues
and instructions on how to change the settings, see "Changing the Port after Installing the
Driver," on p. 3-42.
Install Canon LPR2, and change the port settings.
If you do not want to use Canon LPR2, proceed to step 2.
For instructions on how to install Canon LPR2 and set ports, see the Canon LPR2 User's Guide
(PDF manual). For instructions on how to display the Canon LPR2 User's Guide, see the
Network Quick Start Guide.
If you want to use Canon LPR2, the port changes are complete.
IMPORTANT
If you want to use LPD, enter one of the following in [LPR Queue Name] in the [Add Port] dialog
box of Canon LPR2.
- LP
The machine prints according to its spool settings. Normally enter <LP> as a print queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk, regardless of its spool
settings.