● If you are using an SMTP server that does not require authentication for
7
3
8
9
The e-mail/I-fax settings are complete.
Startup Time Settings
If you connect the machine to a switching hub, it may not be able to connect to a network even
though your network settings are set correctly.
This occurs because the spanning tree process performed between switching hubs prevents
them from communicating with each other immediately after the machine connects to a
switching hub.
In this case, use the following procedure to delay the start of communication.
1
3-30
Protocol Settings
sending e-mail:
❑
Press [SMTP Server] ➞ enter an SMTP server IP address or name.
Input Example :
IP address: 192.168.1.1
Name: smtp.organization.company.com
❑
Press [Authent./Encryption] ➞ press [Off] both for <SMTP Authentication (SMTP AUTH)>
and <POP Authentication before Sending>.
❑
Press [OK].
The display returns to the E-mail/I-Fax screen.
Confirm the settings you entered ➞ press [OK].
Press [Done] repeatedly until the Additional Functions screen closes.
Restart the machine.
❑
Turn OFF the machine, wait at least 10 seconds, and then turn it ON again.
NOTE
For instructions on how to turn ON/OFF the machine, see Chapter 1, "Before You Start Using
This Machine," in the Reference Guide.
➞ [System Settings] ➞ [Network Settings].
Press