ADEMCO Vista-20HW Installation Instructions Manual page 38

To stop the Device action and turn off the lamp, we do not want to use a
restore of any zone, so a "O"will be programmed for the Restore
of
Zone List
(ZL). We will use a manual entry of User Code + [#] + [8] + Device # to
turn off. Therefore, we do not need to program a STOP event.
Press [*I to continue.
-
The system will display a summary screen for the START programming for
device 01. Press [*I to continue.
The system will display a summary screen for the STOP programming for
device 01. Press [*I to continue.
The system will display the "X1O?' prompt. Enter 1 for yes.
The Enter Device No. prompt for the next zone will be displayed.
Press 00 and then [*] to exit the *8O mode.
Now use *81 Zone List mode to program the 3 specific zones in Zone List 1.
Zone List Displays
~
~]
01 Del Zn List?
Press *81. (Zone Lists for Output Devices). This interactive mode is
applicable only if you have programmed MO mode.
Refer to the Programming Form worksheet for *81 Mode.
Upon keying *81, this screen will appear. Enter the Zone List Number 01,02,
or 03 to program (or 00 to end these entries). Press the [*] key to advance.
In the following displays, zone list 01 has been selected for programming,
Enter each zone number to add to the zone list by first entering the zone
number, then the [*] key (example, 01*, 02*, 03*). After all zones desired are
entered, press 00 to advance.
To delete the zone list, enter 1 (Yes). All zones in the zone list will be deleted
automatically. and programming will return to the first screen.
O= Nol=Yes O To save the zone @t, enter () (N;) to advmce.
w
~"
lfktSCreeIl
To save the entire zone list, enter O (No) and programming will return to the
O To delete a zone or zones ~ a zone list enter I ~es) to advace.
IF===ll
Enter each zone to be deleted fkom the list, followed by the [*] key. After all
zones to be deleted are entered, enter 00 to return to the first screen so that
I (00= Quit)
00
another list can be programmed, if desired.
Notes:
" Any list may include any or all of the system's zone numbers.
A zone list can be assigned to more than one output relay.
If you only want to review what has been programmed previously, enter
[#1[8][11. The review can be advanced by using the [*] key. When finished,
enter [01[0] *to quit. No programmed values can be changed in this mode.
When programming in *8O and *81 interactive modes is completed,
exit the programming mode by keying *99.
Unplug the AC transformer.