ADEMCO Vista-20HW Installation Instructions Manual page 67

Press
*65
OPEN REPORT CODE
Part'n In Part'n 2
This is sent upon disarming of the system. 2nd digit. User No.,
if expanded or 4+2 reporting is selected.
See TO PROGRAM SYSTEM STATUS AND RESTORE REPORT CODES
explanation on previous page for fields %6-*76, and *89.
Press
W
Press
*68
Press *69
Press *7O
Press *71
Press *72
Press *73
Press *74
Part'n 1 Part'n 2
ARM AWAY/STAY REPORT CODE
0 0
A~A~ S!l'AY AWAY S'1'A~
This option allows for independent programming of AWAY and
STAY reports for each partition. 2nd digit of Report is User No., if
expanded or 4+2 reporting is selected.
Note: Open reports are not sent in if the system was armed
STAY and Stay reports not programmed.
I
CANCEL REPORT CODE
/J-l
This is sent upon disarming of the system after an alarm
condition was reported.
~~-~--
u
Enter Oif a report is desired for QL@ zone restoral, as it occurs.
This is the default. Enter 1 if a report is not desired until all
zones have restored.
Note "l" not applicable to Contact ID reporting.
ALARM RESTORE REPORT CODE, 1st DIGIT
u
This is sent when the zone that caused an alarm is restored to its
non-faulted condition. 2nd digit is automatically sent as the 2nd
digit of the zone alarm report code programmed in field *56, if
expanded or 4+2 reporting is selected.
TROUBLE RESTORE REPORT CODE
M
This is sent when a trouble in a zone is restored. Field *69
applies.
BYPASS RESTORE REPORT CODE
u
This is sent when a zone that has been bypassed is un-bypassed.
Field *69 applies.
AC RESTORE REPORT CODE
u
This is sent when AC power has been restored iifter an AC power
outage. Reports with Partition 1 Subscriber No.
LOW BAT RESTORE REPORT CODE
u
This is sent when a system low battery condition is restored to
normal.
Press *76 TEST RESTORE REPORT CODE
m I
This is sent when the test mode is exited. Reports with Partition
1 Subscriber No.
Press *89 EVENT LOG 80% FULL REPORT CODE
n I
If an Event Logging selection is made in field *90, a message csn
be sent to the central station receiver when the log is 80% full.
Note: Aside horn the selection made by the installer in field WO,
all log control and readout is accomplished via the Downloader.
-67-