ADEMCO Vista-20HW Installation Instructions Manual page 76

Enter Zn Num.
(00 = Quit) 00
II
17
Zone Type
Not
used 00
I
17 Delete
Zone?
II
Custom Alpha Editing: For all zone types, the next request is to
enter Alpha descriptors for the zones. The entry may be done now
(enter 1), or maybe done at a later time via *82 mode (enter O).
See Section 14. ALPHA DESCRIPTION PROGRAMMING for w
procedure.
When all entries to be made for the zone at this time are complete, the
next zone number can be entered for programming, or zone
programming can be ended by entering [0][0] as the next "zone
number".
Notes:
1.
In jleld *56, at the summary line for each zone, the entered values
can be checked. If it is desired to change anything, press [#] to
move to the previous entry. Press [#] a number of times to move to
earlier entries. Press [*I to move to later entries again.
2. Zone entries can be reviewed by pressing [#][5][6]. Changes cannot
be made here, so this is safer for review. Enter the first zone
number to be viewed and press [#l. To view each zone, press [#]
and the zone number will advance to the next programmed zone.
When the end of the list is reached, press [01[0] to exit. This
method of exiting may also be done at any time during the review.
3. To either temporarily or permanently remove a zone from the
system, go into programming mode and press
[*][5][6].
Enter the
zone number and press [*I. At the "Zone Type" prompt, enter [01[01
and [*I. This sets the type of the zone to "Not Used". The next
prompt will be "Delete Zone?". "Yes" will permanently remove the
zone from the system, while "No" will disable it but retain all data
1
I= Yes O=NO
II
except the ori~nal zone type. You can then go back to this zone
later and put back an active Zone Type to re-enable it.
TO PROGRAM
SYSTEM STATUS
AND RESTORE
REPORT CODES
(*59 - *76, & #419)
The following is a set of guidelines to be used for programming report codes.
The actual digits that you enter depend upon the particular installation, and
should be in agreement with you and the central station office receiving the
signals. Use these guidelines to program this entire section.
With a 3+1 or 4+1 Standard Format: Enter a code in the first box: 1-9, A,
B, C, D, E, or F. Enter "#+10" for A (this reports a "O" on some receivers),
"#+11" for B, "#+12" for C, "#+13" for D, "#+14" for E, "#+15" for F.
An entry of "O" in the first box will disable a report.
An entry of "O" in the second box will result in automatic advance to the
next field when programming.
With an Expanded or 4+2 Formati Enter codesin both boxes (lst and 2nd
digits) for 1-9, or A-F, as described above.
An entry of "O" in the first box will disable a report.
k entry of "O" in the second box will eliminate the expanded message for
that report.
With Ademco Contact ID Reporting Enter
a digit
in the first box to
enable the zone to report. Use a different digit for each zone until you have
used up available digits. If the number of zones exceeds the number of
available digits, begin with digit 1 again. This is an "enabling" code only and
is not the actual code sent to the central station office. Entries in the second
boxes will be ignored. For system status (non-alarm) codes, enter a "1" in the
first box for all the system conditions you want to send to the central station.
An entry of "O"in the first box will disable the report.
-76-