ADEMCO Vista-20HW Installation Instructions Manual page 35

2
STOP (STP):
A) 1.
B). 1.
2.
If a "SYSTEM OPERATION" is chosen (e.g., End of Exit
Time), that operation will cause the device to activate as
selected in "ACTION." The different choices for "ZONE
TYPE" and "SYSTEM OPERATION" are listed in
"Programming Output Relays & Powerline Carrier devices"
later in this section, and in the Programming Form.
PARTITION No. (P). The device's "Start" ZONE
TYPE/SYSTEM OPERATION may be limited to an occur-
rence on Partition 1, Partition 2, or any partition (A).
The "STOP" programming determines when and under
what conditions the device will be de-activated. The
following options are available:
RESTORE ZONE LIST (zL). If a "ZONE LIST" is used
as the "Stop" event, the device will de-activate when all
the zones in that list restore from a previous fault, trouble,
or alarm condition. This will occur regardless of what is
programmed to "START" the device; therefore, a
"RESTORE ZONE LIST' would normally only be used
when a "ZONE LIST' is used to start the device.
ZONE TYPE/SYSTEM OPERATION (ZT). Instead of
using a "RESTORE ZONE LIST, a specific zone (response)
type or system operation action can be selected to de-
activate the device.
If a specific "ZONE TYPE" is chosen, any zone of that
response @e that restores born a previous alarm, trouble,
or fault condition will cause the device to de-activate,
If a "SYSTEM OPERATION is chosen, that operation will
cause the. device to de-activate. The dMerent choices for
"ZONE TYPE" and "SYSTEM OPERATION' are listed in
"programming Relays & Powerline Carrier devices" later
in this section, and in the Programming Form.
PARTITION No. (P). The device's "Sto~" Zone
-35-