ADEMCO Vista-20HW Installation Instructions Manual page 57

When entering Zone ~
Descriptors usin~Method
z, the keypad keys
perform the following
function=
[3]
[1]
[6]
[8]
Scrolls both alphabet
and actual words in
ascending alphabetical
order.
Scrolls both alphabet
and actual words in
descending alphabetical
order.
Selects between alpha-
bet and actual word list;
also used to savewords.
Stores the zone descrip-
tion in memory.
SummuryModeDisplay
DefaultDescriptor$
p), ZONEOI ,,
FlashingCursor(systemis
readyfor entryof word).
4
+i+ZNOl~
Flashing C ursor $
* ZN 01 HACK
II
+f
ZN
01 BACK
A
t
FlashingCursorif "6" is
pressed (systemis ready
for nextword).
++ ZN 01 BACK
El D OOR
t
FlashingCursor
4.
*
5.
6.
7.
8.
Press "O" (No).* The system will
then automatically display the
descriptor for zone 1.
The procedurefor addingcustomwordsto
the built-invocabularywill be found later
under"AddingCustomWords".
If a descriptor was not entered
previously for zone 1, the default
descriptor for zone 1 will be dis-
played.
Note that this a "summary mode",
and that no entries can be made.
Entries can be made only when the
display contains a flashing cursor,
which signifies the "entry mode".
To delete or change the default
descriptor for zone 1, press * plus
the same zone number (01). This
will clear that descriptor and gain
access to the entry mode with
flashing cursor, allowing changes to
be made.
NOTE: If you do not wish to change
the existing descriptor. for zone 1,
enter * plus the next zone number for
which you wish to enter (or check) a
descriptor. A summary display for
that zone will appear. You must then
press * plus the same zone number
again to gain access to the entry mode
(flashing cursor) for that zone.
Press # plus 3-digit number for the
first word from the
"Alpha
Vocabulary List". Example: The
descriptor that we wish to enter for
zone 1 is BACK DOOR. From the list,
BACK = 013. Therefore, you would
enter# O 1 3.
Note: If you accidentally enter the
wrong word, simply press # plus the
correct 3-digit number for the word
you want.
Press "6" to accept the selected
word and continue.
Note: If this is the only word you are
using for the descriptor, press "8"
instead of "6" to save that word in
memory, and then go to step 11.
Enter the 3-digit number for the
next word. In our example, the word
is DOOR, whose number is "057".
Enter # O 5 7. This display will
appear:
-57-