Matrox Axio Installation And User Manual page 84

64
format, and the video output will be downconverted (this includes appropriate
color space conversion from HD to SD).
If the Aspect Ratio Conversion list is available, such as when the video
7
output for an HD sequence is downconverted to NTSC or PAL, select one of
the following settings for the video output:
$
$
If the Pulldown Method list is available, select the pulldown method you
8
want to be applied to your output video ( Standard 2:3 or Advanced
2:3:3:2
output format, a pulldown method may automatically be selected.
Select Allow Super White to allow the highest luminance level of your
9
video output to exceed the standard maximum white level. Select Allow
Super Black
below the standard black level.
¦ Note
your final video production for broadcast.
Under Analog Setup (NTSC) , select the setup level you want for your
10
NTSC analog video (this affects both the input and output):
$
$
Under Advanced Settings , use the following sliders to make timing
11
adjustments to your video output:
$
$
Click OK to save your settings and return to the Sequence Settings dialog
12
box.
Chapter 7, Defining Your Adobe Premiere Pro Settings
Outputs the widescreen 16:9 picture in letterbox mode
16x9 Letterbox
by adding black bars at the top and bottom of the picture for display on a
standard 4:3 television screen.
Anamorphic Outputs the widescreen 16:9 picture as horizontally
compressed 4:3 video, which retains the picture's full vertical resolution
for display on a widescreen television. To display the video with the
correct proportions on an NTSC or PAL monitor, select the 16:9 display
setting on the monitor.
). Depending on your sequence's frame rate and the current master
to allow the lowest luminance level of your video output to fall
Super white and super black should not be allowed when producing
0 IRE Applies a setup level of 0 IRE. You should select this option only
when working with a commercial DV device that uses the Japanese
analog NTSC setup of 0 IRE. For example, if the video appears too bright
when you play back DV clips on your NTSC monitor, you can change the
setup to 0 IRE to output your DV clips at the correct brightness.
7.5 IRE Applies the standard NTSC setup level of 7.5 IRE.
SC/H Phase Advances or delays the video output's subcarrier phase
with respect to the horizontal sync of your genlock source (for composite
video only).
SDI Horizontal Delay
SDI video output.
Advances or delays the horizontal timing of the