Table of Contents
Advertisement
32
Connect the internal power supply cable to your
X.io card
Your X.io card requires power from your computer's internal power supply. An
internal power supply cable is provided with Matrox Axio to connect your X.io
card to your computer's internal power supply.
Attach the small end of your
internal power supply cable to
the 8-pin male connector
located near the rear of your
X.io card.
X.link breakout box
connector
¦ Note
the LED display on your X.io card is not used.
When you've completed the installation of your X.io card and turned on your
computer, an LED display on the backplate of your X.io card will light up,
indicating that the internal power supply is properly connected.
Install your Matrox X.io card
Your Matrox X.io card is designed to operate in your computer's PCI-X slot. If
the slot in which you'll be installing your X.io card contains another card, either
move it to an unused slot or remove it completely. If you want to use a 133-MHz
slot, then you must configure the slot to run at 100 MHz in the computer's BIOS,
or using a jumper on the computer's motherboard. For details about configuring
your computer's PCI-X slots, see your computer's documentation.
To determine the particular slot in which you should install your X.io card for
recommended systems and motherboards, contact your Matrox Axio dealer.
Chapter 4, Installing Your Matrox Axio HD or SD Hardware
LED display
The connector located between the X.link breakout box connector and
Internal
power
supply
cable
X.io card
Advertisement
Table of Contents
