Table of Contents
Advertisement
¦ Note
The higher the DC precision value that's used to capture or render
your video, the more likely that the DC content will be increased at the expense
of the AC content in the encoded stream. This may result in lowering the
overall quality of the compressed stream at a specified data rate.
Under Zig Zag Type , select one of the following:
6
Regular
$
coefficient of the DCT block as defined in the ISO/IEC 13818-2 (figure
7-2) specification documentation.
Alternate
$
coefficient of the DCT block as defined in the ISO/IEC 13818-2 (figure
7-3) specification documentation. Use this setting when capturing or
rendering video at a high data rate (that is, at a data rate of about 50
Mb/sec for SD video, or 100 Mb/sec or higher for HD video).
Select the Force Frame-based DCT setting to render macroblocks as
7
frames rather than as fields. In some cases, graphics will yield less artifacts if
this option is selected.
Click OK to save your settings.
8
Sets the regular (default) zig zag scanning pattern of the AC
Sets an alternate zig zag scanning pattern of the AC
Selecting your MPEG-2 I-frame settings
89
Advertisement
Table of Contents
