Table of Contents
Advertisement
80
$
¦ Note
format available to capture analog or SDI video for a sequence that has a 10-bit
video processing format, and is not available for an 8-bit sequence. If you want
to capture to a format other than Matrox 10-bit Uncompressed , you can
switch the video processing format (on the General page) to 8-bit, and then
change back to 10-bit after you've completed your capture.
$
$
If you're capturing to a Matrox MPEG-2 format, click the Configure button
9
to configure your MPEG-2 settings. For details on the available settings, see
"Selecting your MPEG-2 I-frame settings"
MPEG-2 IBP settings"
click OK to return to the Matrox Capture Settings dialog box.
If you're capturing Panasonic VariCam material, select Enable VariCam
10
capture
Matrox Axio will remove the redundant (filler) frames from the VariCam
input during capture and create a clip in the same format as your sequence
for editing.
¡ Important When you select Enable VariCam capture , audio cannot be
captured. When batch capturing VariCam clips, you must indicate that you
want to capture video only by selecting Video on the Logging pane of the
Capture
11
Select Use Automatic Gain Control (AGC) if you want the gain of your
composite or S-Video input signal to be adjusted automatically to
compensate for very bright or dark images. This improves the brightness or
contrast of your picture. (Available when capturing from X.linkLE or
X.linkSD only.)
From the Input Type list, select the type of equipment you're using for
12
capture:
$
Chapter 7, Defining Your Adobe Premiere Pro Settings
Matrox 10-bit Uncompressed
uncompressed format.
On Axio LE, Matrox 10-bit Uncompressed is the only capture
Matrox MPEG-2 I-frame
format using the 4:2:2 Profile @ Main Level at a selected data rate (SD
resolution only). For the best results when capturing video clips on which
you'll be applying chroma key effects, you should use this codec instead
of a DV codec.
Matrox MPEG-2 I-frame HD
format using the 4:2:2 Profile @ High Level at a selected data rate (HD
resolution only). This is the only capture format available to capture
analog or SDI video for a 1440×1080i sequence.
(supported only for a 720p @ 23.98 fps or 25 fps sequence).
panel under Setup.
Broadcast-quality Source
broadcast-quality. This setting provides the best capture results for most
devices.
Captures video to 10-bit
Captures video to MPEG-2 intra-frame
Captures video to MPEG-2 intra-frame
on page 88, or
on page 90. Once you've configured your settings,
Select this if your source device is
"Selecting your
Advertisement
Table of Contents
